Turn lamps (flasher), Brake On-Off (BOO) lampsĢ003-2004, Diesel: Fuel Injection Control Module (FICM) relayĢ005-2007: Trailer tow Electric Brake Controller (EBC)Ģ003-2004: Brake pressure switch, Speed controlĢ005-2007: Tow haul, Blower relay, Electronic Automatic Temperature ControlĢ002-2004: 4-Wheel Anti-lock Brake System (4WABS) module, Variable Fan Control (VFC) (2003-2004, Diesel)Ģ002-2004: EATC module, Front blower relay coilĢ002-2004: Clutch interlock switch (manual transmissions only), Transmission range sensor (automatic transmissions only) then to starter relay coil (all transmissions), 4x4 To reinstall the cover, align and engage the two hooked clips at the bottom of the cover onto the instrument panel, then lift the panel and press the top clips firmly into place. When the top clips of the panel disengage, let the panel fall easily. To remove the fuse panel cover, pull the panel downward by the finger slots on top of the panel.
Remove the panel cover to access the fuses. The fuse panel is located below and to the left of the steering wheel by the brake pedal. If a fuse blows again contact a qualified service center.Use always an intact fuse of the same color. Never replace a broken fuse with anything other than a new fuse.Using a fuse with a higher amperage rating can cause severe wire damage and could start a fire. Always replace a fuse with one that has the specified amperage rating.Always disconnect the battery before servicing high current fuses.Before replacing fuses check that the key has been removed from the ignition and that all the services are switched off and/or disengaged.
0 kommentar(er)
